Table of Contents
Advertisement
Additional Information
Self-diagnosis
function
Your TV is equipped with a self-diagnosis function. If there is a
problem with your TV, the STANDBY indicator flashes red. The
number of times the STANDBY indicator flashes indicates the
possible causes.
Front of TV
1
Check that the red flashes of the STANDBY indicator is about 3 seconds per
interval.
2
Count the number of times the STANDBY indicator flashes.
3
Press POWER to turn off your TV.
4
Inform your nearest Sony service center about the number of times the
STANDBY indicator flashes.
Be sure to note the model name and serial number located on the rear of
your TV.
Downloaded from
www.Manualslib.com
POWER
STANDBY
indicator
Additional Information
manuals search engine
Troubleshooting
If you find any problem while viewing your TV, please check the following guide. If
any problem persists, contact your Sony dealer .
Symptom
Snowy picture
• Check the antenna cable and connection
on the TV, VCR and on the wall.
(page 4)
• Preset the channel again. (page 9)
Noisy sound
• Check the antenna type (VHF/UHF).
Contact a Sony dealer for advice.
• Adjust the antenna direction. Contact a
Sony dealer for advice.
• Try using a booster.
• Turn off or disconnect the booster if it is
Distorted picture
in use.
Noisy sound
Good picture
• Check the power cord, antenna and the
VCR connections.
• Press POWER on the remote.
• Press POWER on the TV to turn off the
TV about five seconds, then turn it on
Noisy sound
again.
• Press VOL + to increase the volume
Good picture
level.
• Press MUTING to cancel the muting.
• Press MTS until a good sound is heard.
No sound
26
25
Additional Information
Possible cause
Solutions
• Connection is loose or the
cable is damaged.
• Channel presetting is
inappropriate or
incomplete.
• The antenna type is
inappropriate.
• The antenna direction is
inappropriate.
• Signal transmission is low.
• Broadcast signals are too
strong.
• The power cord, antenna
or VCR is not connected.
• The TV is not turned on.
• The volume level is too
low.
• The sound is muted.
• Broadcast signal has a
transmission problem.
Advertisement
Table of Contents
