Auxiliary Input Socket - Sangean U4 DBT Operating Instructions Manual

Setting the Backlight timeout
Your radio can be set to timeout the backlight. The backlight timeout
setting can be adjusted between ON,10, 20, 30, 45, 60, 90, 120
and 180 seconds.
. Access the menu for the current mode by pressing the Menu button.
. Rotate the Tuning control until 'System ' appears on the display.
Press and release the Tuning control.
3. Rotate the Tuning control until 'Backlight' is shown on the display.
Press the Tuning control to enter the setting menu.
4. Rotate the Tuning control to select the desired time. The options
are on (backlight will be on all the time),10, 20, 30, 45, 60, 90,
0, or 80 seconds.
5. Your radio will switch off the backlight after the preset time has
elapsed.

Auxiliary input socket

A 3.5mm Auxiliary input socket is provided on the right side of your
radio to permit an audio signal to be fed into the unit from an external
audio device such as an iPod, MP3 or CD player.
. Connect a stereo or mono audio source (for example, iPod, MP3
or CD player) to the Auxiliary input socket (marked 'Aux In').
. Press the Power to switch on your radio.
3. Press the Source button until the Auxiliary Input band is selected.
4. Adjust the Volume control on your iPod, MP3 or CD player to
ensure an adequate signal and then adjust the volume on the radio
for comfortable listening.
Note: Never use the Aux-In socket in rainy or moist conditions to
prevent moist from entering the radio. Always keep the rubber cover
on the back well closed under these conditions.
45