Operating Your Radio - Fm Auto-Tune - Sangean U4 DBT Operating Instructions Manual

Operating your radio - FM auto-tune

. Straighten up the antenna.
. Press the Power button to switch on your radio.
3. Press and release the Source button until the FM band is selected.
4. Press and release the Auto tune button to cause your radio to
search from low frequency to high frequency and to stop automatically
when it finds a station of sufficient strength.
5. After a few seconds the display will update. The display will show
the frequency of the signal found. If the signal is strong enough
and there is RDS data present then the radio may display the
station name.
6. To find other stations press the Auto tune button as before. When
the end of the waveband is reached, your radio will recommence
tuning from the opposite end of the waveband.
7. Adjust the Volume to the required setting.
8. To switch off your radio, press the Power button.
Note:
If you find that FM reception is poor, try repositioning the antenna.