Samsung SCW61 Service Manual page 62

4-3-3 Adjustment
1. Kinds of adjustment in PLAY mode.
ADDRESS NAME
HD SWP
061
32. 768 KHZ CLOCK
062
MODEL CODE
063
D.ZOOM SIZE
064
TBC DEFAULT
065
2. Adjustment
* Please keep the order according to explanation.
2-1. Setting of the model code0
a. Preparation
TAPE NONE
EQUIPMENT POWER SOURCE
OTHER NONE
TEST POINT NONE
ADDRESS 063
NAME MODEL CODE0
b. Connect a power source.
c. Get into the VCR adjustment mode.
d. Press the ÒBLC(MODE UP)Ó or
ÒFADE(MODE DOWN)Ó button of Camcorder
so as to select the address 063.
e. Press the ÒDSE(DATA DOWN)/P.AE(DATA
UP)Ó so that OSD showsÒ ÓERR:XX EVR: XXÓ
ÒXXÓ is different dependent on the model as
below.
MODEL NAME
SCW61
NTSC
SCW62
VP-W60
VP-W61
PAL
VP-W63
f. Be sure to press the ÒENTER(CONFIRM)Ó but-
ton on Camcorder to memorize setting.
g. Reset the power source so as to fix the new data
to the CamcorderÕs EEPROM.
Samsung Electronics
NORMAL MODEL
NTSC
05
ADDRESSED CODE
74
74
60
64
67
PAL NTSC
Adjustment
1C
Model code setting
50
05
01
2-2. Head Switching Point
: This adjustment is performed after the
replacement of deck mechanism.
¥ Without this adjustment, there will be a noise
in playback picture.
a. Preparations
STANDARD COLOR BAR TAPE
RECORDED WITH SP SPEED
TAPE
*NTSC
EQUIPMENT POWER SOURCE
OTHER NONE
TEST POINT NONE
ADDRESS 061
NAME HD SWP
b. Connect a power source.
c. Get into the VCR adjustment mode.
d. Press the ÒBLC(MODE UP)Ó or ÒFADE(MODE
DOWN)Ó button of Camcorder so as to select
the address 061.
e. Insert the Standard Color Bar Tape and press
the ÒPLAYÓ button.
Note : If there is no video out, when you pressed
the ÒPLAYÓ button, you can not adjust the
Head Switching Point.
It may be caused by maladjusted VIDEO
block.
In this case, adjust the VIDEO block before
the Head Switching Point.
Alignment and Adjustment
HI 8 MODEL
PAL
01
4-43