Loading A Disc - Fujitsu LifeBook C-7651 Manual

Loading a Disc

IMPORTANT
• You should preferable power the computer from the AC adapter when frequently accessing the
CD. A frequent access to a CD consumes a large amount of electrical power.
• To set a disc on the disc tray, align the center of the disc with the projection at the center of the
tray and push the disc down until it clicks into place.
Otherwise it may come off in the drive, causing damage to the disc tray and drive or the disc
itself.
• When you are using a CD that starts automatically when it is loaded, don't put your computer
into standby mode. If you place the computer into standby (suspending operation) mode while
using an auto-run CD, the CD will start twice when you resume system operation (when you
restore the operation at the point at which you suspended operation), and this could cause the
computer to malfunction. If you let the CD start twice, exit all programs on the CD, and load it
over again.
• When data is being read, the CD runs at very high speeds and sometimes causes vibration
and hiss noise.
1. Press the EJECT button.
The disc tray pops out.
EJECT button
2. Pull out the tray gently.
Disc tray
55