Delta Signal Amplifier (Art.-No. 200 130) And Power Supply (Art.-No. 200 010) - Sitec DELTA 2.0 Operating Instructions Manual

Delta Signal Amplifier (Art.-No. 200 130) and Power Supply (Art.-No. 200 010)

If you want to connect a 3rd or 4th extension
on the client side, you'll need the Delta signal
amplifier to increase the performance of the
signal transmission or to enable transmission
over longer distances. The signal amplifier
needs an additional power supply.
The connection socket marked Combi is
provided to connect combined extensions.
The following devices can be connected here:
Desktop Extension (Art.-No. 200 140),
Built-in Extension (Art.-No. 200 141),
Three-Panel-Strip (Art.-No. 200 145) and
Door Intercom (Art.-No. 200 165).
The signal amplifier can be connected to the
central control via Public 3 or Public 4.
Attention: Only
components to the signal amplifier and to the
central control when the power supply / plug
is disconnected.
You can also connect a combination of
loudspeaker and microphone via the signal
amplifier. To do this, connect the built-in
loudspeaker (Loudspeaker) and microphone
(Microphone) plugs to the labeled sockets (as
can be seen on the right).
Alternatively, single
microphone cables can be connected via
screw terminals on the back of the signal
amplifier. A connection diagram is printed on
the device. The screw terminals on the back
and the plug connection sockets on the front
are connected in parallel.
The signal amplifier can be connected to the
central control via Public 3 or Public 4.
Attention: Only connect
components to the signal amplifier and to the
central control when the power supply / plug
is disconnected.
SITEC GmbH © 2012
connect individual
loudspeaker and
the individual
www.sitec.de 28