Kenwood KIV-700 Service Manual page 18

KIV-700/BT900
At specialists (or specialty stores), when the installer sends
the vehicle back to the user, they may make the store-rec-
ommended audio confi guration.
When the user changes the setting values, when the backup
power supply was taken out at times of battery change or
when the reset button was pressed, to make it possible to
recall the setting values, the store-recommended confi gura-
tion values can be saved into E2PROM.
The specifi cation detail defer in "with-DSP model" and in
"without-DSP model".
[Models with DSP]
· Calling and saving the confi guration is done by the multi-
function key. ([Preset-1])
· Items to be saved are Car Type, Position, Speaker, EQ,
X'over, Car Type Adjust, and Sub Woofer Level. Only
one setting can be saved for each item. (EQ setting can
be changed for each source, but only one setting can
be saved as the installer memory specifi cation, and the
18
INSTALLER MEMORY SPECIFICATIONS
source in which the saving operation was carried out is
saved as such.)
Also, the setting values of all Preset Positions will be
memorized for the setting value of DTA. (6 speakers x4)
· The contents read out by the call key shall be refl ected
only to the current source at the time. → EQ curve is
"USER". (EQ setting can be changed for each source, but
not refl ected to EQ settings of sources other than where
the calling operation was carried out.)
· When the backup power supply was taken out at times
of battery change or when the reset button was pressed,
as the initial setting values of Car Type, Position, Speaker,
EQ, X'over, Car Type Adjust, and Sub Woofer Level, the
saved memory is refl ected (EQ setting initial setting value
memory is refl ected in all sources).
NOTE: By such, EQ curve initial setting shall always be
"USER". (NOT "NATURAL" or "FLAT".)