Kenwood KIV-700 Service Manual page 14

KIV-700/BT900
Seek stop level manual adjustment mode
• Image of display
M N N _ 3 . 9 8 V
M N L _ 4 . 4 4 V
The value saved in E2PROM as the default value is displayed.
• Operation procedure
1) In the band in which Local Seek ON/OFF switching is allowed, press [TEL] or [TI] or [PLAY MODE] key briefl y to switch on
or off the Local Seek (Local Seek ON/OFF).
2) Press key, [ ] / [ ] to manually adjust the seek stop level between 0.00V and 4.70V (E type) or 0.00 and 5.00V (K/M type)
depending on the respective destination (You can keep pressing the key to adjust the level.)
∗ As for the K/M/E type, you may fi nd that the key keeps moving toward DOWN direction for a while even after 0.00V is
set, however at any rate the level is set to 0.00V as it is displayed.
3) Press and hold [AUD] key for 2 seconds to write the present reception level in E2PROM as the seek stop level. After the
successful completion of writing the level in E2PROM, "EP_WRITE" shall be displayed.
∗ At this time, use Local Seek ON/OFF to change where to write in the level (Destination of the writing-in).
5. Press [ ] key briefl y to exit from TUNER setting adjustment mode. (Keep running the test mode)
RDS automatic measurement function
• Objectives
This function is implemented in place of the PS display visual inspection that has been carried out in the manufacturing line in
order to reduce the process.
• Functional description
After receiving PS data and confi rming that contents of PS is displayed as "RDS_TEST", forcibly turn OFF the P-CON terminal.
(Note that "_" is to indicate the blank space.)
∗ This is the function dedicated only to the test mode, and it shall be designed that P-CON is recovered by cycling the power (i.e.,
POWER OFF→ON).
Special display in TUNER source (Display of front-end error)
If the following display is shown in TUNER source, it indicates an error in the front-end or in others.
• Image of display
T N E 2 P _ N G
T N C ON _ N G
K3I forced switching
In TUNER FM band, the switching in the following sequence is carried out every time when "6" key is pressed: AUTO→Forced
WIDE→Forced MIDDLE→Forced NARROW→AUTO.
The initial condition is AUTO.
• Image of display
AUTO
a F 1
Forced WIDE
wF 1
Forced MIDDLE
mF 1
Forced NARROW n F 1
■ USB source test mode
Set 23 in the Volume setting value by pressing and holding [SEARCH MODE] key for 1 second.
14
TEST MODE
(In the case of Normal [Local OFF])
(In the case of Local [Local ON])
Front-end E2PROM has its default value (indeterminate value)
Communication between front-ends NG
9 8 . 1
9 8 . 1
9 8 . 1
9 8 . 1