Kenwood KIV-700 Service Manual page 11

Attached table 1: Version & service information display mode
Software version & serial number display
• Description
System μ-com software version, SoC μ-com software version, Serial No., Destination setting, ROM correction ver-
sion are displayed.
The BT related version is also displayed as the model with the built-in BT (KIV-BT900).
• Software version display
The following numbers are added at the head of the system μ-com version number and the number with this
added number is displayed.
· System μ-com
· SoC μ-com
• System μ-com ROM correction version display
· Display specifi cation
[Rotary]
(Counter
clockwise)
↑
↓
· Image of display
[Rotary]
[1]
Ex. In the case of the model with the built-in BT (KIV-BT900)
(Clockwise)
(Remote
S Y S 0 1 –
controller)
S o C
or
S N o _ x x x x x x x x
C 0 9 5 5 W K
S T Y P E : x x
[DISP]
S Y S _ R O M _
∗ Press this
Ex. In the case of the model without the built-in BT (KIV-700)
key briefl y
S Y S 0 2 –
to switch
S o C
the display
S N o _ x x x x x x x x
C 0 9 4 8 W x
S T Y P E : x x
S Y S _ R O M _
↓ ↑ Remote controller [1] key or [ ]/[ ] can be used to switch
• Display of BT related version information (KIV-BT900)
· Layout of display
· Image of display
B T _ V E R : H W x x x _ S W x x x
A D D R
P I N
TEST MODE
Built-in BT (KIV-BT900) : 01
Without built-in BT (KIV-700) : 02
For all destinations
When ROM correction data is written in: SYS_ROM_R1234
When ROM correction data is not yet written in: SYS_ROM_R_ _ _ _
When inconsistency is found in ROM correction data: SYS_ROM_R∗∗∗∗
∗ When the data cannot be applicable (cannot be used) because the source code and ROM correction
data are inconsistent.
1 . 2 3
– 8 1 . 3 4
R 1 2 3 4
1 . 2 3
– 8 1 . 3 4
R 1 2 3 4
1st line : BT module H/W & S/W Version
2nd line : BT module Device Address
3rd line : BT module PIN Code
: x x x x x x x x x x x x
: x x x x x x x x
KIV-700/BT900
Ex. SYS01_∗.∗∗
Ex. SYS02_∗.∗∗
Ex. SoC___∗.∗∗
11