Method Of Operation; Adjust The Volume; Adjust The Bass; Adjust The Treble - Chery Tiggo Owner's Manual

Method of Operation

Operation
Notice:
Please refer to the above figure of front panel "Panel
Instruction" to read this chapter.
Please lower the sound volume before
turning off the ignition switch or main power.
Device can keep the memory of finial setting of
volume value before turning off. If the volume is very
high before turning off, the sudden high volume may
hurt your ear or damage your device when you turn it
on in next time.
Power ON or OFF
Notice:
If the engine of the vehicle doesn't start up, you shall be
careful of device operation in long time, since the vehicle
may not be able to start up if the battery power is low, also
the service life of the battery may be reduced.
Press the POWER button to turn on/off the CD player.
Mode Selection
1. Press the BAND (FM/AM) button to select the required
band.
2. Press the CD button to select the CD play mode.

Adjust the Volume

Turn the knob in clockwise direction to increase the
volume; and turn the knob in anticlockwise direction to
decrease the volume.
The Max. volume is 31 and Min. volume is 0.
Please ensure that you can hear the traffic signals (whistle,
alarm,).

Adjust the Bass

1. Press the SEL button to select the"BASS".
2. Turn this button in the clockwise direction to increase the
bass; and turn the button in anticlockwise direction to
decrease the bass.
*Its value is set as "0" before leaving factory.
The range of adjustment: -7 to +7.
3. After the completion of adjustment, long press
the SEL button to finish the setting.

Adjust the Treble

1. Press the SEL button to select the "TREB".
2. Turn this knob in clockwise direction to increase
the treble; and turn the knob in the anticlockwise
direction to decrease the treble.
*Its value is set as "0" before leaving factory.
The range of adjustment: -7 to +7.
3. After the completion of adjustment, long press
the SEL button to finish the setting.

Adjust the Balance

1. Press the SEL button to select the "BAL".
2. Turn this button in clockwise direction to
increase the volume of right speaker; and turn the
button in anticlockwise direction to increase the
volume of left speaker.
*Its value is set as "0" before leaving factory.
3. After the completion of adjustment, long press
the SEL button to finish the setting.
Audio
33