Connect Lead; Start Engine - Chery Tiggo Owner's Manual

Emergency Procedure
Engine Jump-start Method
If the battery of the vehicle has no power, battery
power of other vehicles can be input to help the
engine to start.
Only a battery of the same nominal voltage (12V)
can be connected. Use jump leads with insulating
clips and cables of proper sizes. Please do not
disconnect the battery from the electrical system of
the vehicle.
112

Connect Lead

Low
power
battery
Supporting
battery
1. Park the vehicles properly so that they do not
contact each other.
2. Stop the engine and any other unnecessary
electrical devices.
3. Connect the positive (+) terminal of the low
battery with the positive (+) terminal of the
supporting battery using lead A.
4. Connect one terminal of lead B with the negative
(-) terminal of the supporting battery, and then
connect the other terminal of lead B with the metal
part of the engine to be started. Position the
jumper leads to prevent it from contacting the
running parts of the engine compartment.
5. Make sure that the jumper cables do not
interfere with the running parts of the engine.
The negative (-) terminal of the low
battery shall not be connected.

Start Engine

1. The engine of the vehicle with the supporting
battery shall run at a properly high speed.
2. Start the engine of vehicle with the low battery.
3. Before disconnecting the leads, run the engines
of the two vehicles for three minutes.