Led Indicator; Sub Lcd Indicator; Lcd Display In Panel Test Mode; Frequency And Signaling - Kenwood NX-210 Service Manual

■ Key operation
"FNC" not appears on the sub LCD display
Key
Function
[Selector] -
Push: Test channel up
[ ] Hold: Test channel up
continuously
Push: Test channel down
[ ] Hold: Test channel down
continuously
Push: Squelch level up
[Side1]
Hold: Squelch off
[Side2] Wide/Narrow/Very narrow
[ ] Shift to panel tuning mode -
[ ] Function on
[ ] MSK 1200bps and 2400bps 2400bps:
Push: Test signaling up
[ ] Hold: Test signaling up
continuously
[Orange] -
[PTT] Transmit
Use as the DTMF keypad.
[0] to [9] If a key is pressed during
and transmission, the DTMF
[#], [ ] corresponding to the key
that was presses is sent.
"FNC" appears on the sub LCD display
Key
Function
[Selector] -
[ ] Function off
[ ] Analog/NXDN
[Side1] Function off
[Side2] LCD all lights
[ ] High power/Low power
[ ] Function off
[ ] Compander on/off
[ ] Beat shift on/off
[Orange] Function off
[PTT] Transmit
[0] to [9]
and Function off
[#], [ ]
ADJUSTMENT
Display
-
Channel No.
Channel No.
Squelch level
Squelch off: icon appears
Wide: "w"
Narrow: "n"
Very narrow: "v"
"FNC" appears on the sub
LCD display
icon appears
Signaling No.
-
-
-
Display
-
-
Analog: "A"
NXDN: "N"
-
LCD all point appears
High: "H"
Low: "L"
-
On: icon appears
On: icon appears
-
-
-

• LED indicator

Red LED Lights during transmission.
Green LED Lights when there is carrier.

• Sub LCD indicator

"FNC" Appears at function on.

• LCD display in panel test mode

(Power ON)
Market code
(After 2sec.)
Temperature
Sub LCD display
Main LCD display
An: Analog narrow mode
Aw: Analog wide mode
Nn: NXDN narrow mode Squelch level
Nv: NXDN very narrow mode (Analog mode only)

■ Frequency and Signaling

The transceiver has been adjusted for the frequencies
shown in the following table. When required, readjust them
following the adjustment procedure to obtain the frequen-
cies you want in actual operation.
• Test frequency
CH RX (MHz)
1 155.05000
2 136.05000
3 173.95000
4 155.00000
5 155.20000
6 155.40000
7~16
NX-210
Frequency range
"F1": 136~174MHz
Battery type detect
" L I ": Li-ion battery
" N I CD ": Ni-Cd battery
" N I MH ": Ni-MH battery
" I S ": IS Ni-MH battery
Power
Channel No. Signaling No.
TX (MHz)
155.10000
136.10000
173.90000
155.00000
155.20000
155.40000
- -
37