Inserting The Rubber Spacer; Removing The Lithium Cell; Mounting The Chassis Onto The Case; Installing The Lithium Cell - Kenwood NX-210 Service Manual

■ Inserting the rubber spacer (J30-1279-04) onto
the rear panel
1. Bend the two convex parts of the rubber spacer inward q,
then fi t the sheet into the space w.
Next, bend the one convex part of the rubber spacer in-
ward e, and insert the sheet into the rubber spacer.
2. Press the rubber spacer, using your fi ngers, to insert it
between the rubber spacer and the rear panel without
crevice.
Rubber spacer (J30-1279-04)
Sheet (G11-4493-04)
Circle nut
Apply the bond (W05-0019-00) or "THREE BOND 1401B"
around the inside of the circle nut before tightening the
circle nut.

■ Mounting the chassis onto the case

1. Place the key top on the chassis. Then, fi t the chassis
tightly into the groove of the key top q.
Note:
Confi rm that the entire groove of the key top fi ts to the
chassis tightly.
2. Press the microphone part of the key top using your fi n-
ger w.
Note:
Confirm that the microphone part of the key top fits
tightly with the element microphone.
3. Mount the chassis onto the case e.
Note:
After mounting the chassis onto the case, if the 18-key
part on the key top or the Auxiliary (Orange) key part of
the VOL/CH packing gets stuck inside the case as shown
in the fi gure, return it to the normal position using a soft
tipped item (e.g., your fi nger) r.
Prying it with a pointed metal tool such as forceps, may
damage the key top or packing.
DISASSEMBLY FOR REPAIR
■ Removing the lithium cell (W09-0971-05)
Insert a non-conductive screwdriver to groove of one
side of the socket (CN203) and pry the lithium cell up
from the socket.
■ Installing the lithium cell (W09-0971-05)
Insert a lithium cell into one side of the socket (CN203).
Push the lithium cell to insert the lithium cell into the
socket.
NX-210
18-key part
Auxiliary
(Orange) key
9