Troubleshooting - McCulloch Li 40T Operator's Manual

TROUBLESHOOTING

PROBLEM
String will not advance when
using the bump-feed head.
Grass wraps around shaft
housing and string head.
Motor fails to start when switch
trigger is depressed.
TROUBLESHOOTING
POSSIBLE CAUSE
String is welded to itself.
Not enough string on spool.
String is worn too short.
String is tangled on spool.
Cutting tall grass at ground level
Battery is not secure.
Battery is not charged.
Shaft not connected completely
SOLUTION
Replace string.
Install more string. Refer to string
replacement earlier in this manual.
Pull string while pressing line release button.
Remove string from spool and rewind. Refer
to string replacement earlier in this manual.
Cut tall grass from the top down to prevent
wrapping.
To secure the battery pack, make sure the
latch on bottom of the battery pack snaps into
place.
Charge the battery pack according to the
instructions included with your model.
Make sure lower shaft is fully seated in shaft
coupler on upper shaft and secure shaft
coupler.
English - 15