Contents INTRODUCTION............2 TROUBLESHOOTING..........11 SAFETY................3 TECHNICAL DATA............12 ASSEMBLY..............7 ACCESSORIES............13 OPERATION..............8 CONTENTS OF THE EC DECLARATION OF CONFORMITY..............13 MAINTENANCE............10 INTRODUCTION Operator's manual The initial language of this operator's manual is English. Operator's manuals in other languages are translations from English. Overview 1.
Only use an approved trimmer head, spool Read this manual and recommended trimmer line. Do not use blades. Use approved head protection Keep bystanders away Use approved hearing protection Guaranteed sound power level The product or packaging cannot be handled as domestic waste. The product Use approved eye protection and packaging must be submitted to an appropriate recycling station for the recovery...
Page 4
• Stay alert, watch what you are doing and use common sense when operating a power tool. Do not use a power tool while you are tired or under the CAUTION: Damage to the product. influence of drugs, alcohol or medication. A moment of inattention while operating power tools may result in serious personal injury.
• Keep cutting tools sharp and clean. Properly • Use the machine only in daylight or good artificial maintained cutting tools with sharp cutting edges are light. less likely to bind and are easier to control. • Never operate the machine with damaged guards or •...
• Do not use the product if it is changed from its initial object, the object can eject and cause injury or specification. Do not change a part of the product damage. Unwanted material can wind around the without approval from the manufacturer. Only use cutting attachment and cause damage.
Examine the cutting attachment guard for damage and • Do not use a battery pack or product that is replace if it is damaged. Only use the approved guard defective, changed or damaged. for the cutting attachment. • Do not change or repair products or the battery pack. Only let your approved dealer do repairs.
To change the position of the loop To attach the cutting attachment guard handle and the trimmer head (straight shaft) 1. Attach the cutting attachment guard (A) to the shaft with the bolts (L). Make sure to use the correct cutting attachment guard and the correct trimmer head.
Page 9
To trim the grass Note: If the trigger is released during operation, the product starts in the last mode. If the product • Hold the trimmer head immediately above the automatically stops, or if the operator pushes the power ground at an angle. button, the last used mode is erased from memory.
4. Use full throttle. 5. Make sure that the trimmer line ejects the cut material into an area that was cut before. To use the twist and edge button The twist and edge button of the product lets the operator turn the trimmer head. This makes it easier to edge along walks or driveways.
TROUBLESHOOTING Problem Possible cause Possible solution To start the motor on page 8 . The product The power is off. Start the power. See does not start To install the battery pack No electrical contact between Install the battery pack correctly. See on page 8 .
• If the battery pack is too hot, especially after operation, move the battery pack and battery charger away from the hot environment. TECHNICAL DATA unit Li 58T (BLT58VPR) Motor specifications Motor type Brushless Motor voltage V (DC) Motor power...
McCulloch Harmonized standards and/or technical specifications Platform / Type / Model Platform BLT58VPR, rep- applied are as follows: EN ISO 12100, EN resenting model Li 58T 60335-1, EN 50636-2-91, EN 62233, EN 55014-1, EN Batch Serial number dating 2017 55014-2...
Page 14
manufacturing locations and Countries of Origin, as stated on the product. The supplied grass trimmer conforms to the example that underwent examination. On behalf of Husqvarna AB, SE 561 82 Huskvarna, SWEDEN, 2017-12-04 John Thompson, Product and Marketing Director Responsible for technical documentation 455 - 002 - 20.11.2017...