Starting And Stopping; To Install Battery Pack; To Remove Battery Pack; Starting/Stopping The Trimmer - McCulloch Li 40T Operator's Manual

WARNING! Do not allow familiarity
!
with products to make you careless.
Remember that a careless fraction of
a second is sufficient to inflict serious
injury.
WARNING! Always wear eye protection.
!
Failure to do so could result in objects
being thrown into your eyes resulting in
possible serious injury.
WARNING! Never use blades, flailing
!
devices, wire, or rope on this product. Do
not use any attachments or accessories
not recommended by the manufacturer
of this product. The use of attachments
or accessories not recommended can
result in serious personal injury.
For complete charging instructions, refer to the
Operator's Manuals for your battery pack and charger
models.
NOTE: To avoid serious personal injury, always
remove the battery pack and keep hands clear of the
lock-out button when carrying or transporting the tool.

To install battery pack

• Align raised ribs on battery pack with grooves in the
trimmer's battery port and slide battery into position
as shown.
• Make sure the latch on the back of the battery
pack clicks into place and that battery pack is fully
seated and secure in the trimmer before beginning
operation.

To remove battery pack

• Release the switch trigger and lock-out trigger to
stop the trimmer.
• Press the power button to turn off the trimmer.
• Press and hold the battery latch button (a) on the
back of the battery pack.
• While holding the battery latch place one hand on
the trimmer handle and remove battery pack.
10 - English

STARTING AND STOPPING

a

Starting/Stopping the trimmer

To start:
• Press the on/off power button.
• Depress the lock-out button and squeeze the switch
trigger.
• Press high speed button to increase speed
depending upon grass condition. Two LED's will
illuminate above the high speed button indicating
that the trimmer is in the high speed setting.
To stop:
• Release the switch trigger.
• Press the power button again to turn the unit off.
NOTE: The unit will power itself down after being idle
for 1 minute.
Hight/Low speed button
On/Off button
Lock-out
button
Switch trigger