Setup; Control Panel And Menu Navigation; Dmx Address Setting; Wdmx Control - NURI-LITES HIGHBALL User Manual

Setup

Warning! Read "Safety Information" on page 3 before installing, powering, operating or servicing
the fixture.

Control panel and menu navigation

The onboard control panel and backlit graphic display are used to set the fixture's DMX address,
configure individual fixture settings (personality), read out data and execute service utilities. See "Onboard
control menus" on page 15 for a complete list of menus and commands.
Using the control buttons
To enter a menu, select a function or apply a selection, press ► (Enter).
l
Press ▲ (Up) and ▼ (Down) to scroll within a menu or adjust values.
l
To escape a function or move back one level in the menu structure, press ◄ (MODE).
l
Holding down the "UP" or "DOWN" button for more than 3 seconds, the MENU display rotated 180°
l

DMX address setting

The DMX address, also known as the start channel, is the first channel used to receive instructions from the controller.
For independent control, each fixture must be assigned its own control channels.
The DMX address is configured using the DMX ADDRESS menu in the control panel.
If no DMX signal is present, the display background will flicker.
l

WDMX control

Press the button "UP" to switch off Wireless DMX or disconnect with all connected Transmitters.
Press the button " DOWN' to set the unit in the "ready to connect with all not connected transmitters'
mode. If you press the mode button on the Wireless solution transmitter all the ready to connect units
will be connected.
If the unit is successfully connected in the home display the sign"
a transmitter or switched off no"
symbol does not indicate wireless signal strength.
Note:
" sign is visible.
11
" appears. If the unit is not connected to