Table of Contents

Advertisement

SETUP

Warning! Read "Safety Information" on page 2 before installing, powering, operating the fixture.
Control panel and menu navigation
The onboard control panel and backlit graphic display are used to set the fixture's DMX address, configure
individual fixture settings (personality), read out data and execute service utilities. See "Onboard control
menus" on page 14 for a complete list of menus and commands.
Using the control buttons
• To enter the menu select [MODE].
• Press [UP] and [DOWN] to scroll within a menu or adjust values.
• To enter a menu, select a function or apply a selection, press [ENTER].
• To escape a function or move back one level in the menu structure, press [MODE].
• Holding down the "UP" and "DOWN" button for more than 3 seconds, the MENU display rotated 180°.
DMX address setting
The DMX address, also known as the start channel, is the first channel used to receive instructions from the controller.
For independent control, each fixture must be assigned its own control channels.
The DMX address is configured using the DMX ADDRESS menu in the control panel. When setting the DMX address,
press [ENTER] before you can change the address.
• In order to check if there is a DMX signal present on the fixture you can easy see that via the big ‚DOT' on the
main screen and also when the backlight function is switched to off.
• The fixture is fully RDM ready. So when you are using a RDM ready console you can address the unit and
read out its complete status. For RDM functions please refer to the ANSI/ESTA E1.20-2006 standard
Control mode
DMX control mode is selected in the CONTROL MODE menu. The fixture has 6 DMX control modes:
Dimmer
RGBW
Strobe
CCT
Macro color
Effect
Dimmer /Effect speed
Function set
Hue
Saturation
Value
Intensity
4ch
6ch
HSV
7ch
11ch
HSI
8.0

Advertisement

Table of Contents
loading

Table of Contents