Page 2
table of CONTENTS Dimensions Safety Information Fixture overview Introduction AC power Power voltage Power cables Relaying power to other devices Data link Connecting the data link Tips for reliable data transmission Physical installation Fastening the fixture to a flat surface Setup Control panel and menu navigation DMX address setting...
WARNING! Read the safety precautions in this section before installing, powering, operating or servicing this product The following symbols are used to identify important safety information on the product and in this manual: DANGER! DANGER! WARNING! WARNING! WARNING! WARNING! WARNING! Safety hazard.
Page 5
Do not expose the fixture to rain or moisture Refer any service operation not described in this manual to a qualified technician. Socket outlets used to supply fixture fixtures with power or external power switches must be located near the fixtures and easily accessible so that the fixtures can easily be disconnected from power.
fixture overview 5P DMX input 5P DMX output 3P DMX input (optional) 3P DMX input (optional) AC mains power AC mains power input throughput LCD Display Control buttons Safety cable attachment point G Clamp with Quicklock #875760 (optional) Omega bracket with Quicklock #520114 (optional)
Introduction Outdoor RGBW LED Fixture UNIQUE BRACKET DESIGN ¢ TOURING PROOF ¢ SMOOTH RGBW COLOR MIXING ¢ IP65 RATING ¢ ¢ SILENT OPERATION SMOOTH PROJECTION ¢ ® POWERCON TRUE IN & OUT ¢ RDM READY ¢ Using for the first time Warning! Read “Safety Information”...
powercables Power input and throughput cables must have a 20 A minimum rating, have three conductors with a minimum conductor size of 1.5 mm² (16 AWG) and an outer cable diameter of 5 - 15 mm. Cables must have a hard usage type jacket (SJT or equivalent) and be heat- resistant to a 90°C minimum.
Physical installation Warning! The fixture must either be fastened to a flat surface such as a stage or wall, or clamped to a truss or similar structure in any orientation using a rigging clamp. Warning! The fixture can cause injury or damage it if falls, attach an approved safety cable to one of the safety cable attachment points on the base (see “Fixture overview”...
SETUP Warning! Read “Safety Information” on page 2 before installing, powering, operating the fixture. Control panel and menu navigation The onboard control panel and backlit graphic display are used to set the fixture’s DMX address, configure individual fixture settings (personality), read out data and execute service utilities. See “Onboard control menus”...
Static Color options There are three options for static color: FIXED Color Several options from combinated RGBW values. Use Up and Down to scroll through the options. R = Red RB = Red & Blue BW = Red & White G = Green GB = Green &...
Auto show The auto function gives 10 auto programs and custom programs RGBW color combinations which are working Hit [ENTER] to adjust the speed of the without any DMX console. Auto program from 1-20. Auto program 1 pre-program 1 1) Auto 1 11) Program 1 Auto program 2 pre-program 2...
dmx protocols Function Value Setting Remark 0 - 100 Saturation 0 - 100 Value 0 - 100 Note: In HSV mode, Hue stands for the visible light, such as red, yellow, and cyan, etc. Saturation refers to the dominance of hue in the color; when saturation is at 100%, then the color is at its purest. Value is the color's brightness; when value is at 100%, then the color is at its brightest.
Limited Warranty Nuri*Lites LED fixtures (the Product) are warranted by TMB against defective materials or workmanship for a period of one (1) year from the date of original sale by TMB. TMB’s warranty shall be restricted to the repair or replacement of any part that proves to be defective and for which a claim is submitted to TMB before the expiration of the applicable warranty periods.