Safety Information - NURI-LITES HIGHBALL User Manual

Safety Information

Read the safety precautions in this section before
installing, powering, operating or servicing this
The following symbols are used to identify important safety information on the product and in this manual:
DANGER! DANGER!
Safety hazard.
Hazardous
Risk of severe
voltage. Risk of
injury or death.
lethal or severe
electric shock.
Warning! Risk Group 3 (high risk) LED product according to EN 62471. Do not look into the beam at a distance
of less than 8.3 meters from the front surface of the product. Do not view the light output with optical
instruments or any device that may concentrate the beam.
This product is for professional use only. It is not for household use.
This product presents risks of severe injury or death due to fire and burn hazards, electric shock and falls.
Read this manual before installing, powering or servicing the fixture, follow the safety precautions listed below and
observe all warnings in this manual and printed on the fixture. If you have questions about how to operate the fixture
safely, please contact your supplier
PROTECTION FROM ELECTRIC SHOCK
Disconnect the fixture from AC power before removing or installing any cover or part and when not in use.
l
Always ground (earth) the fixture electrically.
l
Use only a source of AC power that complies with local building and electrical codes and has both overload and
l
ground-fault (earth-fault) protection.
Before using the fixture, check that all power distribution equipment and cables are in perfect condition and rated for
l
the current requirements of all connected devices.
Power input and throughput cables must be rated 20 A minimum, have three conductors 1.5 mm² (16 AWG) minimum
l
conductor size and an outer cable diameter of 5 - 15 mm. Cables must be hard usage type (SJT or equivalent) and
heat-resistant to 90° C minimum.
Use only PowerCon cable connectors to connect to power input sockets. Use only PowerCon cable connectors to
l
connect to power throughout sockets.
Isolate the fixture from power immediately if the power plug or any seal, cover, cable, or other component is
l
damaged, defective, deformed, wet or showing signs of overheating. Do not reapply power until repairs have been
completed.
WARNING!
product
WARNING! WARNING!
LED light
Fire hazard.
emission. Risk of
eye injury.
4
WARNING! WARNING!
Burn hazard. Hot Wear protective
surface. Do not
eyewear.
touch.
WARNING!
Refer to user
manual.