Ac Power; Power Voltage; Power Cables And Power Plug - NURI-LITES HIGHBALL User Manual

AC power

Warning! Read "Safety Information" starting on page 3 before connecting the fixrures to AC mains power.
Warning! For protection from electric shock, the fixture must be grounded (earthed). The powerdistribution
circuit must be equipped with a fuse or circuit breaker and ground-fault (earth-fault)protection.
Warning! Socket outlets or external power switches used to supply the fixture with power
near the fixture and easily accessible so that the fixtures can easily be disconnected from power.
Important! Do not insert or remove live PowerCon connectors to apply or cut power, as this may cause arcing at
the terminals that will damage the connectors.
Important! Do not use an external dimming system to supply power to the fixture, as this may cause damage to
the fixture that is not covered by the product warranty.
The fixture can be hard-wired to a building electrical installation if you want to install it permanently, or a power plug that is
suitable for the local power outlets can be installed on the power cable.

Power voltage

Warning! Check that the voltage range specified on the fixture s serial number label matches the local AC mains
power voltage before applying power to the fixture.
The fixtures accept AC mains power at 100-240 V nominal, 50/60 Hz. Do not apply AC mains power to the fixture at any
other voltage than that specified on the fixture's serial number label.
,
8
must be located