Assembly - Philips 330 Service Manual

Depart. Technical support- CM640
PHILIPS Consumer
Communications
Centre du Mans
9.2

Assembly

9.2.1 Inserting LCD Module
1 - Insert the flex in the flip split.
2 - Put the LCD module in the flip front between 2 limits.
9.2.2 Buzzer positioning
- Put the buzzer at the correct place,
- Flip hole and earpiece have to correspond
- Buzzer have to be on the adhesive
Adhésive part
9.2.3 Flip rear inserting
1 - First insert the left side from the flip in the correct position
2 - Push on the front flip to active the 4 clips
1
9.2.4 Flip Screwing
Screw the 4 screws on the flip looking out the autoforming:
- With specific screw driver, turn the screw to the left to find the thread
- After that you have to screw to the right and stop when it's little bit more difficult
 PHILIPS ELECTRONICS N.V. 1999
All rights reserved. Reproduction in whole
or in part is prohibited without the written
consent of the copyright owner.
PROCEDURE
Service Repair Support
2
0.1N/m
COMPANY RESTRICTED
1
Flip hole
VY-V-640-P330
Page : 35 of 43
Langue : EN
Date : 11/06/03
VY-V-640-P330