To Swing Back Auto-Vari Unit; To Lift Up Control Panel Assembly - Hammond 340107 Service Manual

TO SWING BACK AUTO-VARI UNIT:
1) Remove two 1/4" hex head screws from the metal rail on the right and left
sides of the Auto-Vari chassis as shown in Figure C, Number 1.
2) Gently lift the Auto-Vari unit and swing the chassis backward towards the
rear of the console to a horizontal position, as shown in Figure C, Number 2.
TOP
LEFT
VIEW
~;,.-
~
...
~<D
I
~
AUTO·VARI
HINGE
©
0"'­
<,
<,
<,
o
o
@
®o
o
rW
TO LIFT UP CONTROL
PA.~EL
ASSEMBLY:
1) Follow steps to swing back the Auto-Vari unit.
2) Remove two 1/4" hex head screws from the mounting brackets at the extreme
left and right sides of the console as shown in Figure D, Number 1.
3) Gently lift the Control Panel assembly and pivot backwards, as shown in
Figure D, Number 2.
CAUTION: THE CONTROL PANEL ASSEMBLY MUST BE FIRMLY SECURED WHEN PLACED IN THE
UPRIGHT POSITION, OTHERWISE IT MAY FALL, CAUSING DAMAGE TO ORGAN PARTS
OR PERSONAL INJURY.
2 -2 I 3401J7 PKELItHNARY
~