Disassembly Procedure; To Remove Rear Cover; To Remove Top Cover - Hammond 340107 Service Manual

,.­
DISASSEMBLY PROCEUURE
TO REillVE REAR COVER:
1) Remove ten 5/16 11 hex head screws from the rear cover. Pull the cover
away from the console.
TO REillVE TOP COVER:
1) Remove two 1/4 11 screws that secure the swing down panel, as shown in
Figure A, Number
1.
2) Fold down the swing down panel as shown in Figure A, Number 2.
3) Loosen the nylon cords that extend the swing down panel as shown in
Figure A, Number 3.
4) Remove two 1/4" hex head screws from the right and left sides of the top
rail as shown in Figure B, Number 1.
5) Unplug the three prong plug from the Music Light assembly on the left side
of the Auto-Vari unit, as viewed from the rear of the console, as shown
~
I
in Figure B, Number 2.
6) Reach in from the rear of the console and release the latch on the right
and left sides on the front side of the console, pulling the latch towards
the rear of the console, as shown in Figure B, Number 3.
-
7) Gently lift the top cover up and away from the console, as shown in
Figure B, Number 4.
"(J)
' ( J)
I
/
",..-...
REARVIEW
®
340107
PRELIMI,~ARY
I
2-1