Call Intercept; Base Ringer; Temporarily Turning Off The Message Alert Tone - AT&T CL82107 User Manual

Answering system
About the answering system

Call intercept

While screening a call, you can stop recording and speak to the caller by
pressing .

Base ringer

Press pVOLUME+ or on the telephone base to adjust
qVOLUME-
the ringer volume when the telephone is not in use.
You hear a sample of the ringer while adjusting the volume. The
telephone base announces, "Base ringer is off," when you set the
volume to 0.

Temporarily turning off the message alert tone

If the message alert tone is turned on, the telephone base beeps
every ten seconds when there are new messages. Pressing any
FIND HS) temporarily silences the
telephone base key (except
message alert tone.
However, if you press a key at the telephone base to silence the
message alert tone, the telephone base will also perform the
corresponding key function. For example, if you press X/DELETE
when in idle mode to temporarily turn off the message alert tone,
there is a voice prompt directing you to press X/DELETE again
to delete all old messages. The message alert tone is temporarily
off. Only press X/DELETE a second time if you wish to erase all old
messages in your answering system.
The message alert tone resumes when you receive another
message.
116