Set Up A Wireless Mouse And Keyboard; Wireless Mouse - InFocus MONDOCENTER 3 Hardware Manual

SET UP A WIRELESS MOUSE AND KEYBOARD

This section only applies to the InFocus mouse and keyboard which ships to some countries. Refer to the manufacturer's
documentation, if another mouse and keyboard are being used.
Note: For initial setup and/or configuration, it may be easier to use a mouse and keyboard. Any standard wired or wireless mouse or
keyboard, connected through the MondoCenter USB ports, is supported by MondoCenter.

Wireless Mouse

1) Turn the mouse over and remove the battery cover.
2) Remove the USB dongle from its holder in the battery compartment of the mouse.
3) Plug the dongle into one of the USB connectors on the front panel of the MondoCenter. You may be asked to go online to find the
necessary drivers. If you are warned that the drivers have not been tested for compatibility, tap Continue installation to finish.
4) Insert two (2) AAA batteries (not included) into the mouse by aligning the batteries' polarity and sliding them in place.
5) Replace the cover and move the slide switch next to the battery bay on the bottom of the mouse to the ON position.
MondoCenter3 Hardware Guide Page 9