TV and the cabinet sides • Overheating through poor ventilation will should be about 10 cm in an enclosed cabinet. shorten TV life and may be a fi re risk. 5385 LD1701 Goodmans UK.indd 3 5385 LD1701 Goodmans UK.indd 3 21/04/05 9:57:23 21/04/05 9:57:23...
Page 4
• The monitor could fall causing injury to a child or adult and specifi cations at the back of this booklet). serious damage to the monitor. 5385 LD1701 Goodmans UK.indd 4 5385 LD1701 Goodmans UK.indd 4 21/04/05 9:57:25 21/04/05 9:57:25...
Page 5
• This may result in a fi re hazard ! Appearance of power plug and socket will vary according to the country where this product is used. 5385 LD1701 Goodmans UK.indd 5 5385 LD1701 Goodmans UK.indd 5 21/04/05 9:57:26 21/04/05 9:57:26...
15 minute break every 2 hours. Do not use the unit against a bright back ground and where sunlight or other light sources will shine directly on the screen. 5385 LD1701 Goodmans UK.indd 6 5385 LD1701 Goodmans UK.indd 6 21/04/05 9:57:28...
Page 7
Limitation of use This television is only designed for household or similar general use as described in these instructions. Any other use might invalidate the guarantee and be dangerous. 5385 LD1701 Goodmans UK.indd 7 5385 LD1701 Goodmans UK.indd 7 21/04/05 9:57:32...
Push the built-in stand into its parking position. Purchase and fi t a VESA standard 75mm wall mounting kit, taking care that fragile walls and wall fi xings have adequate strength to support the monitor (approximate weight 5.5kg). 5385 LD1701 Goodmans UK.indd 8 5385 LD1701 Goodmans UK.indd 8 21/04/05 9:57:33...
Connect the female end of the power cord to the power input socket on the LCD Monitor. Then, plug the male end of the power cord into an AC outlet. Don’t switch on until all connections are completed. 5385 LD1701 Goodmans UK.indd 9 5385 LD1701 Goodmans UK.indd 9 21/04/05 9:57:33...
We recommend you do not use cable end adapters or gender changers as these sometimes miss out or cross over the DDC connections 5385 LD1701 Goodmans UK.indd 10 5385 LD1701 Goodmans UK.indd 10...
BLUE GROUND DDC stands for Data Display Channel. This makes Plug and Play work, so the computer matches the graphics adapter settings to the monitor. D-SUB 5385 LD1701 Goodmans UK.indd 11 5385 LD1701 Goodmans UK.indd 11 21/04/05 9:57:37 21/04/05 9:57:37...
(We do not give advice on using these applications, but there is plenty on the Internet). 5385 LD1701 Goodmans UK.indd 12 5385 LD1701 Goodmans UK.indd 12 21/04/05 9:57:40...
2. Press the SOURCE button ( ) on the TV-monitor or the remote control repeatedly to select input signal from TV tuner, scart socket, PC, composite video or s-video. 5385 LD1701 Goodmans UK.indd 13 5385 LD1701 Goodmans UK.indd 13 21/04/05 9:57:42...
(PC, VIDEO, S-VIDEO, TV, SCART) C. MENU Displays and exits the on-screen menus. Use with the volume and channel buttons according to the on-screen menu descriptions on the following pages. 5385 LD1701 Goodmans UK.indd 14 5385 LD1701 Goodmans UK.indd 14 21/04/05 9:57:43 21/04/05 9:57:43...
Page 15
The channel (CH) buttons also work as “UP” and “DOWN” in the on-screen menus. E. VOLUME, LEFT and RIGHT Increases or decreases the sound level. The volume (VOL) buttons also works as “LEFT” and “RIGHT” in the on-screen menus. 5385 LD1701 Goodmans UK.indd 15 5385 LD1701 Goodmans UK.indd 15 21/04/05 9:57:45 21/04/05 9:57:45...
Automatic picture adjustment for PC source. 11. EXIT If you need to connect external Exit the On Screen menus. sources of audio and video, please read “Connecting with external equipment”. 5385 LD1701 Goodmans UK.indd 16 5385 LD1701 Goodmans UK.indd 16 21/04/05 9:57:45 21/04/05 9:57:45...
Page 17
Pres the corresponding colour button on the remote controller to display the subject page. 21. 0, 1, 2, 3,...9 (Number Key) Using the 0, 1, 2, 3...9 Keys, the required channel or Teletext page is selected 5385 LD1701 Goodmans UK.indd 17 5385 LD1701 Goodmans UK.indd 17 21/04/05 9:57:48 21/04/05 9:57:48...
BBC1, key in “1”; BBC2, key in “2”, and so on. Press VOL right to complete. 4. Repeat above steps for the other stations. 5385 LD1701 Goodmans UK.indd 18 5385 LD1701 Goodmans UK.indd 18 21/04/05 9:57:52...
Page 19
“BBC Ceefax 1” and “BBC Ceefax 2” for BBC1 and BBC2. Press teletext ( ) again to exit teletext. 5385 LD1701 Goodmans UK.indd 19 5385 LD1701 Goodmans UK.indd 19 21/04/05 9:57:54 21/04/05 9:57:54...
Press MENU then CH down. In this input menu press volume right or left to change input source then CH down to activate it. Input source is the only menu you can display if the television does not detect any input. 5385 LD1701 Goodmans UK.indd 20 5385 LD1701 Goodmans UK.indd 20 21/04/05 9:57:55...
NTSC is the TV system used in countries like USA and Japan. Saturation (TV Only) Adjust the strength of colour. Same as “Colour” control on a conventional TV Sharpness (AV Only) Adjust the sharpness of the picture. 5385 LD1701 Goodmans UK.indd 21 5385 LD1701 Goodmans UK.indd 21 21/04/05 9:57:56 21/04/05 9:57:56...
Loudness (Loudspeaker Only) Compensate the sound for reduced sensitivity of the human ear to bass and treble audio frequencies at low volume. Turn on and off with the volume buttons. 5385 LD1701 Goodmans UK.indd 22 5385 LD1701 Goodmans UK.indd 22 21/04/05 9:58:00...
Press VOL right or left button to change on-screen display language. You will see a red tick mark to show which language will be used for the on-screen menus. The language changes immediately you move the tick mark. 5385 LD1701 Goodmans UK.indd 23 5385 LD1701 Goodmans UK.indd 23 21/04/05 9:58:02...
A bar graph shows the relative colour intensity. Ex-factory settings are 50% You can use the utility menu “auto” function to automatically balance the colour and other picture settings for a computer video source. 5385 LD1701 Goodmans UK.indd 24 5385 LD1701 Goodmans UK.indd 24 21/04/05 9:58:04...
Press volume right on this function to restore menu adjustments to ex-factory condition, but still keep the TV channel tuning memory. Full Auto (kun PC-modus) Press volume right on this function to perform automatic picture size, position and colour adjustment. 5385 LD1701 Goodmans UK.indd 25 5385 LD1701 Goodmans UK.indd 25 21/04/05 9:58:06 21/04/05 9:58:06...
Region setting will only work if the hardware in the TV supports the TV system for the selected region. There is more about region setting under ‘Tuning your LCD TV”. 5385 LD1701 Goodmans UK.indd 26 5385 LD1701 Goodmans UK.indd 26...
MENU button again to exit. • All menus go off automatically after the time set in the “OSD timer” in the “OSD” menu. Exit Turn off OSD Menu. 5385 LD1701 Goodmans UK.indd 27 5385 LD1701 Goodmans UK.indd 27 21/04/05 9:58:10 21/04/05 9:58:10...
Display image is not centred, too small or to Press AUTO key on remote. large on PC mode. Read ”Connecting a computer” section on page 3. 5385 LD1701 Goodmans UK.indd 28 5385 LD1701 Goodmans UK.indd 28 21/04/05 9:58:10 21/04/05 9:58:10...
Page 29
Switch off main power at the wall outlet and disturbance. wait 10minutes before trying again.(Leave the TV unplugged and call a serviceengineer if this does not work.) 5385 LD1701 Goodmans UK.indd 29 5385 LD1701 Goodmans UK.indd 29 21/04/05 9:58:13 21/04/05 9:58:13...
Sometimes development and improvement of our product means the instructions contain some errors. We apologise for any inconvenience so caused and assure you we make every eff ort to minimise these errors. 5385 LD1701 Goodmans UK.indd 30 5385 LD1701 Goodmans UK.indd 30 21/04/05 9:58:14...
Need help?
Do you have a question about the LD1701 and is the answer not in the manual?
Questions and answers
Is this tv digital or analogue