Setup - Predator 63078 Owner's Manual & Safety Instructions

Set Up
Read the ENTIRE IMpORTANT SAFETY INFORMATION section at the beginning of this manual
including all text under subheadings therein before set up or use of this product.
TO pREVENT SERIOUS INJURY: Operate only with proper spark arrestor installed.
Operation of this equipment may create sparks that can start fires around dry vegetation.
A spark arrestor may be required.
The operator should contact local fire agencies for laws or regulations
relating to fire prevention requirements.
Note: For additional information regarding the parts listed in the following pages,
refer to the Assembly Diagram near the end of this manual.
Components and Controls
Display
1. UNPLUG DEVICES
2. RESET ALL CIRCUIT BREAKERS
3. MAKE SURE DEVICE AMPS ARE LESS THAN 92 TOTAL (120VAC)
HC = Current
Hours
HT = Total
Hours
V = Voltage
Hz = Hertz
IF ANY CIRCUIT BREAKERS TRIP ENSURE THAT ALL CIRCUIT BREAKERS ARE RESET
GFCI Receptacles
120 V AC 20 A
GFCI Receptacles
and Breaker
Page 8
Switch
Choke Knob
ENGINE SWITCH
ON
OFF START
120 V AC 20 A
and Breaker
120 V AC 30 A
Receptacle
and Breaker
Figure A: Control panel
For technical questions, please call 1-888-866-5797.
120 / 2 40VAC
46 A Breakers
12 V DC Receptacle
CHOKE
Pull at Start.
Push when Running.
120 / 2 40 V AC
30 A Receptacle
and Breakers
120 / 2 40 V AC 46 A
Low Oil Indicator
and Breaker
LOW OIL
GFCI
RECEPTACLES
WILL NOT
PROTECT
AGAINST
ELECTRIC
SHOCK IF
GENERATOR IS
NOT GROUNDED
GROUND
Ground
Terminal
Receptacle
ITEM 63078