Predator 63078 Owner's Manual & Safety Instructions page 14

13500 watts
Table of Contents

Advertisement

26. Use a carburetor screwdriver (sold separately) to
remove the Left Main Jet and replace it with the
proper replacement Left Main Jet (A1 or A3) for the
altitude. See Figure R.
27. Use a carburetor screwdriver to remove the
Right Main Jet and replace it with the replacement
Right Main Jet (A2 or A4) for the same altitude
as the Left Main Jet. See Figure R.
Reassembly
Note: Reassembly step references shown in brackets.
1. Replace the Outer and Inner Bowl O-Rings
with the replacements from the altitude kit.
Do not reuse existing O-Rings.
Inner Bowl
O-Ring
Outer Bowl
O-Ring
Carburetor
Bowl
Figure S: Replace Bowl O-Rings
2. Assemble the Carburetor Bowl using four
Carburetor Bowl Bolts. [#25] Assemble Carburetor
Intake Elbow to Intake using Bolts. [#21]
3. Attach Solenoid Valve connector, line up green
wire with the green dot on the connector. [#20]
4. Attach Fuel Pump Bracket to front of intake
using Bolt. Gently lift the Bracket after
assembly to ensure proper alignment. [#19]
Page 14
For technical questions, please call 1-888-866-5797.
Right
Main Jet
(A2/A4)
Note: Since carburetor is upside-down, left
and right sides are reversed.
Figure R: Main Jets
5. Attach the Choke Rod on the right side of the
Carburetor, and secure it with its Clip. [#17,18]
6. Attach the Breather Hose to the Carburetor,
and secure it with its Clamp. [#16]
7. Attach the Throttle Rod Spring to the Throttle Rod
Clip on the left side of the Carburetor. [#15]
8. Insert the Throttle Rod on the left side of the
Carburetor, and secure it with its Clip. [#14]
9. Attach the Fuel Hose to the port at the top of the
Carburetor and attach it using its Clamp. [#12]
10. Install Shroud using four Shroud Bolts and two
Flange Shoulder Bolts. [#9,10] Include the Lifting
Bracket in place on the right Flange Shoulder Bolt.
11. Install Air Cleaner Base using two Air Cleaner Base
Bolts. Connect Fuel Filter Clip under left side of
Air Cleaner Base. Install the Intake Cover and
Intake Screen using the Intake Cover Bolts. [#6-8]
12. Place the Paper Air Filter, Foam Air Filter,
Air Cleaner Spacer, and Air Cleaner Top Cover
into place on the Air Cleaner Base. [#5]
13. Replace the Air Cleaner Front Cover. [#4]
14. Use the Air Cleaner Top Knob and Air Cleaner
Front Knobs to secure the Covers in place. [#3]
15. Once all connections are secure, open fuel valve.
16. Wipe up any spilled fuel and allow excess
to evaporate before starting engine.
To prevent FIRE, do not start the engine
while the smell of fuel hangs in the air.
Left
Main Jet
(A1/A3)
ITEM 63078

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents