Important Safety Instructions; Setup Precautions - Predator 59134 Owner's Manual & Safety Instructions

Safety ......................................................... 2
Setup .......................................................... 7
Specifications ............................................. 7

iMpOrtant SaFEty inStructiOnS

SaVE tHESE inStructiOnS
This manual contains important instructions that should be followed during
installation and maintenance of the Generator and any batteries.
Set up precautions
1. This unit is to be installed so that access is
restricted to only qualified service personnel
who have been instructed of the reasons for the
restrictions applied to the location and about any
precautions that must be taken. Access shall be
through the use of a special tool, or lock and key,
or other means of security and shall be controlled
by the authority responsible for the location.
2. Gasoline fuel and fumes are flammable, and
potentially explosive. Use proper fuel storage
and handling procedures. Do not store fuel
or other flammable materials nearby.
3. Have multiple ABC class fire extinguishers nearby.
4. Operation of this equipment may create sparks that
can start fires around dry vegetation.
A spark arrestor may be required. The operator
should contact local fire agencies for laws or
regulations relating to fire prevention requirements.
Page 2
table of contents
WarninG SyMBOLS anD DEFinitiOnS
This is the safety alert symbol. It is used to alert you to potential
personal injury hazards. Obey all safety messages that
follow this symbol to avoid possible injury or death.
Indicates a hazardous situation which, if not avoided,
will result in death or serious injury.
Indicates a hazardous situation which, if not avoided,
could result in death or serious injury.
Indicates a hazardous situation which, if not avoided,
could result in minor or moderate injury.
Addresses practices not related to personal injury.
For technical questions, please call 1-888-866-5797.
Operation ................................................... 11
Maintenance .............................................. 17
Parts List and Diagram .............................. 25
5. Set up and use only on a flat, level,
well-ventilated surface.
6. All connections and conduits from the Generator
to the load must only be installed by trained and
licensed electricians, and in compliance with all
relevant local, state, and federal electrical codes and
standards, and other regulations where applicable.
7. Connections for standby power to a building
electrical system must be made by a qualified
electrician. The connection must isolate the
Generator power from utility power, and must
comply with all applicable laws and electrical codes.
8. A transfer switch should be installed by a
licensed electrician in compliance with all
applicable laws and electrical codes.
9. Wear ANSI-approved safety goggles, heavy-duty
work gloves, and dust mask/respirator during set up.
ITEM 59134