Personalised Label In Pager; Important Information - Abilia All In One User Manual

Personalised label in pager

A personalised label makes it easier to identify alarms on your pager.
Depending on configuration, you can write the name of residents or the
sensors linked. An extra label is included in the package.
Replacing labels in the pager
1 Remove the transparent plastic cover protecting the panel with coloured
diodes. Avoid damaging the plastic.
2 Replace the label.
3 Snap the plastic cover back into place.
Note: You can download and editable PDF version on our website.
1
"click"
3
Chapter 4
24 Troubleshooting and other information.
2

Important information

This section contains important information about safety, handling, disposal,
recycling and warranty.
Read the manual and all safety information before using All In
One. Keep the manual for future use.
Warning!
• There is a potential risk of fire, electrical shock, or damage to the
product if the safety instructions are not followed.
• Do not use or store this product near any heat sources such as radiators,
naked flames, ovens or any other heat output.
• Protect the cables from any potential source of damage.
• Use only the power supply and accessories specified in this manual.
• Disconnect the power supply from the mains during thunderstorms or if
the product is not in use for a long period.
• If the product is dropped always test it before reusing.
• Please note that the deliberate or accidental switching off of the volume
or power switch on the Pager can result in a missed alarm.
• Be aware that alarms can be missed if batteries run out, connectors become
disconnected, or mobile systems are out of operation. Only refer damaged
or faulty products to qualified service personnel.
• Do not dismantle the product; there is a risk of electric shock. Tampering
with or dismantling the product will void warranty.
• The product is intended to be used as a care alerting system but should
not be used as the only security in life-threatening situations. This product
does not replace the need for personal supervision of patients/users.
• The product has no power switch. In order to disconnect the product, the
charger and power supply must be disconnected from the wall outlet.
Make sure that these are easily accessible.
• The product is designed for indoors use only.
• Do not expose the product to moisture.
• Protect the product from shocks during storage and transport.
Chapter 4
Troubleshooting and other information.
EN
25