Link transmitter to mobile phone
To receive alarms via GSM, the transmitter must be linked to the assistant's
mobile phone. A transmitter can handle up to two assistants. They are
designated Assistant 1 and Assistant 2.
How to link a transmitter
1 Send a text message with Assistant 1's number to the transmitter's mobile
number according to the principle below. Repeat for Assistant 2.
Note: Use space before and after the mobile number.
Assistant 1
ALERT 'MOBILE NUMBER' A1
For example:
ALERT 070123456789 A1
2 To test the link: press the transmitter's test button. The transmitter will
send a text message and call the assistants in the order stated on the
next page. If no text or call is received, see Troubleshooting on page 20.
Repeat steps 1-2 to link a new transmitter. Send the message with the
mobile numbers of the assistants to the new transmitter's mobile number.
1
ALERT
0704313335
A1
Q W E R T Y I O P Å
A S D F H J K L Ö Ä
Z X C V B N M
Note: You can switch assistant by texting the new number to the transmitter
according to the ALERT 'NEW MOBILE NUMBER' A1 principle. To clear all assis-
tant numbers, text DELETE to the transmitter. This action cannot be cancelled.
Chapter 1
8
Install transmitter.
Assistant 2
ALERT 'MOBILE NUMBER' A2
For example:
ALERT 070123456789 A2
2
How it works
1 When a sensor is activated, the transmitter sends an alarm via text mes-
sage to Assistant 1. As a safety precaution, it also makes a call (tone only).
2 Assistant 1 has 20 seconds to respond to the call. To prevent confusion
with voice mail, the call has to be concluded within 10 seconds.
3 If Assistant 1 fails to answer or hang up in time, the text message and call
are redirected to Assistant 2.
1
How to read alarms
1 To quickly be able to see which transmitter is sending an alarm, you need to
enter a contact in your mobile contact list for each transmitter on the system.
Note: Name the transmitter according to the resident's name or room number.
2 When a sensor is activated on any of the transmitters, you will receive a
text message with the following:
Transmitter name (or mobile number if it's not in your address book)
Activated sensor no. 1-4
The example below shows that sensor 1 in Ebba's room has activated.
Arne
Ebba
Ola
Ann
2
3
A1
A2
Ebba
Sensor 1
activated
Chapter 1
Install transmitter.
9
EN