Z-Wave TZ67G Instruction Manual

Z-wave Dimmer
Receiver Switch
Art.no 36-5743 Model TZ67G
Please read the entire instruction manual before using the product
and then save it for future reference. We reserve the right for
any errors in text or images and any necessary changes made
to technical data. In the event of technical problems or other
queries, please contact our Customer Services.
Note:
• The dimmer receiver is intended for indoor use only.
• Remember to use a dimmable bulb in the connected
light fixture.
Product description
• This remote switch/dimmer is intended to be used with
Zipabox Duo and other Z-wave-system products.
• Plug-in-type. Dims and turns plugged in devices on/off,
e.g. lamps.
• Supports 2-way communications, allowing the dimmer
switch to report its on/off status.
• Can be controlled using a smartphone or tablet via
a gateway such as the Zipabox Duo.
• Can also be controlled via remote control (sold separately).
1. Multifunction
button. Controls
the connected
device's power
supply and dimming
1
function, installs/
removes the dimmer
switch from your
control device.
LED indicator.
GREAT BRITAIN • customer service tel: 0845 300 9799 e-mail: customerservice@clasohlson.co.uk internet: www.clasohlson.com/uk
Installation
1. Plug the dimmer switch into a wall socket.
2. Set your Z-wave-control device into learning mode and
press the Multifunction button with a short press in order to
connect it to the dimmer receiver.
3. Connect the light that you wish to control to the dimmer
switch and turn the light on.
A comprehensive user manual is available at
www.tkbhome.com.
Removal
Set your Z-Wave control device in removal mode to remove
the dimmer switch from the controller.
On/off, dimmer (manual)
• Press the Multifunction button shortly to manually turn
the connected light on/off.
• Hold the Multifunction button to toggle the dimming function
in one direction. Release and hold in again to toggle
the dimming function in the opposite direction.
Care and maintenance
• Always disconnect the dimmer receiver from the wall socket
before cleaning.
• Clean the product using a lightly moistened cloth. Use only
mild cleaning agents, never solvents or corrosive chemicals.
Troubleshooting guide
The LED indicator is • Check that the dimmer receiver
off and the dimmer is properly plugged into
receiver does an electrical socket.
not work. • Check that the wall socket
is live.
The LED indicator • Make sure the connected light is
is on but turned on.
the connected light
cannot be controlled.
The LED indicator is • Set the control device to
on but the dimmer learning mode and press
switch does the Multifunction button on
not respond to the dimmer switch.
the control device. • Make sure that the distance
between the devices is not
too great.
• Make sure that there are no
wireless transmission hinders
such as other interfering wireless
devices, walls, ceilings, etc.
Disposal
This product should be disposed of in accordance with local
regulations. If you are unsure how to proceed, contact your
local council.
Specifications
Rated voltage 230 V, 50 Hz
300 W
Load capacity
Range Up to 30 m line-of-sight
Frequency 868.42 MHz