Punch Resist Loop Size (Body); Punch Option Setting - Olivetti PK-512 Service Manual

6. Finisher
6.1.4

Punch Resist Loop Size (Body)

Functions • Adjusts the punch loop size used for paper exited from the main unit.
• To address problems such as misaligned punch holes, wrinkled paper, and jam at the
Use
punch registration section.
Adjustment • Misaligned punched holes: Enter a positive value.
instructions • Wrinkled paper: Enter a negative value.
1. Call the Service Mode to the screen.
2. Touch [Finisher].
3. Touch [FS-FN adjustment].
4. Touch [Punch Resist Loop Size (Body)].
5. Set the correction value using the [+]/[-] keys.
Setting/ 6. Touch [OK] twice to return.
procedure 7. Touch [Exit] on the Service Mode screen.
8. Turn OFF the main power switch, wait for 10 sec., then turn the switch ON.
9. Make a copy again and check the deviation of punch hole position.
10.If the above adjustment does not resolve the problems, perform the punch hole devia-
tion correction.
P.15
6.2

Punch option setting

Functions • Specifies punch settings depending on the optional punch kit attached to the finisher.
• An individual punch setting needs to be made according to the type of the punch
Use
option.
• The default setting is Non-installat.
1. Call the Service Mode to the screen.
2. Touch [Finisher].
3. Touch [Punch option setting].
Adjustment 4. Touch [PK-512] or [PK-513].
instructions 5. Touch [2-Holes/3-Holes] or [2-Holes/4-Holes] or [SWE4 holes].
6. Touch [decision].
7. Touch [END].
8. Touch [Exit] on the Service Mode screen.
9. Turn OFF the main power switch, wait for 10 sec., then turn the switch ON.
14
Service Manual
Field Service Ver. 1.0 Feb. 2007
Y108421-6