Installation Steps; Adjusting The Unit - Turning Ports E2 (Sup) / I2 (Eha); Connecting The Condensate Drain Pipe - Airflow Duplexvent Flexi DV1600 Installation, Use And Maintenance Manual

5.4 Installation steps

●
Before installation remove the wooden transport planks.
●
The versatile design of DUPLEXVENT FLEXI DV1600 and DV2600 allows mounting the unit under the window or in the ceiling.
Window position:
- The appliance is placed on height-adjustable feet (H
- Due to the condensate drain the appliance must be tilted towards section i2 (EHA).
Ceiling position:
- The appliance is suspended from anchors of sufficient load bearing capacity (provided by the building contractor) using four
suspension eyes (included in delivery) with Ø 11 mm holes.
- Due to the condensate drain the appliance must be tilted towards section i2 (EHA), see the picture.

5.5 Adjusting the unit - turning ports e2 (SUP) / i2 (EHA)

●
Only units up to DV1600 can be adjusted in this way.
●
When making the adjustment, follow the diagram below and the visual instructions in the appendix.

5.6 Connecting the condensate drain pipe

●
The unit is versatile and has 4 condensate outlets in total for two directions of air flow and two installation positions. A specific
condensate outlet is always used for a specific application.
- For the window position use the condensate outlet in section i1 (ETA)
- For the ceiling position use the condensate outlet in section i2 (EHA)
= 147 mm) included in delivery.
min
6