Table of Contents
Advertisement
11.
Use
Important:
The device can be used only if it is fitted with cutting tips supplied by your distributor or the
manufacturer of the equipment. They are four-side cutting tips. The device is fitted with 6
cutting tips. It is strongly advisable that you use only genuine cutting tips.
11.1 Setting of the draft
Caution:
While adjusting the machine, use working gloves and other personal protective
equipment. Operations must be performed with the still machine and after the
machine has been disconnected from the compressed air distribution.
Disconnect the compressed air distribution.
Loosen the locking setting screws (fig. 10.0.1, position H)
Turn the guide disc (fig. 10.0.1, position E) to set the draft size. The current settings
can be read from the scale (fig. 10.0.1, position G). The scale is for reference only and
the resulting draft can be other for various angles of cutter heads.
For settings, tighten both the screws (fig. 10.0.1, position H)
Important:
The maximum draft is 15 mm of the bevel width (dimension P, fig. 11.1.1). This draft must be
achieved within multiple steps. It depends on the strength of material. Testing is
recommended.
Start with a smaller draft and increase the value gradually, until the work with machine is
comfortable and the cutting tips are able to carry out continuous draft without any increased
vibrations. For informative settings, use the below-mentioned tables.
We recommend to keep the work log, where you can write down the measured values and
your own machining procedures.
9
Advertisement
Table of Contents
