Change To The Bevel Angle And Shape Replacing Of The Cutter Head - N.KO B15 AIR Operating Instructions Manual

11.3 Change to the Bevel Angle and Shape Replacing of the Cutter Head

The machine B15 AIR is designed for the use of multiple kinds of cutter heads, see chapter
8. Accessories
When replacing the head, proceed as follows:
 Disconnect the compressed air distribution.
 Loosen the locking setting screws (fig. 10.0.1, position H)
 Turn the guide disc (fig. 10.0.1, position E) until you dismantle it fully from the
machine.
 Lock the spindle against turning using the enclosed mandrel (fig. 11.2.1, position E)
 Using the supplied Allen key (fig. 11.2.1, position C) loosen and dismantle the roller
screw (fig. 11.2.1, position B) and the roller (fig. 11.2.1, position A)
 Now dismantle the actual cutter head (fig. 11.2.1, position F) using the supplied hook
spanner (fig. 11.2.1, position D).
 Following the same procedure, install the new head and re-assemble the machine.
 All joints must be tightened properly.
Fig. 11.2.1
12