Table of Contents
Advertisement
Personal Injury Protection
at work, use safety goggles, solid footwear, ear protectors, suitable head wear, e.g. a hard
cap.
Connect the machine to the compressed air distribution only if the starting valve of the
machine is in the OFF position.
Prior to each use, check whether the device or the compressed air supply are not
damaged. Do not use the machine if there are any damages.
Protect the device from moisture and do not use it in the wet environment.
Ensure good lighting of the workplace, so that the risk of possible injury or sight
impairment are prevented.
Caution. The tool (cutter) is sharp. There is a risk of injury. While replacing, use
protective gloves, never touch the cutter when in motion.
The material subject to machining must always be fixed firmly and horizontally. The
optimum workpiece height is 900 mm above the ground.
While working, pay attention to the supply hose; it should always be freely lying on the
ground away from the material subject to machining and any other sharp objects.
After work, disconnect the device from the compressed air supply.
Do not overload the machine engine. The machine works better if it is not overloaded.
While working, hold the machine with both your hands.
Pay attention to the risk of injury by hot metal chips.
Important:
In the event of damage, have your machine repaired by the service authorized to carry out
such repairs. For more information, contact your supplier.
7. Technical Specifications
Bevel angle
Bevel width
Radius
Engine
Engine power
Speed
Air consumption
Working pressure
Weight
Number of Cutting Tips
Fitting of the compressed air inlet G ½"
removable head 30°, 37,5°, 45°, 50°, 60°
other angles upon request
0 to 15 mm < 400N/mm2 - 0 to 8 mm > 400N/mm2
max R3.5mm
pneumatic
2984 W
6000 rpm
750 L/min
6bar
7.5 kg
6 pcs (cutter head for edge rounding - 3 pcs)
6
Advertisement
Table of Contents
