Caution:
While adjusting the machine, use working gloves and other personal protective
equipment. Operations must be performed with the still machine and after the
machine has been disconnected from the compressed air distribution.
11.4 Replacement of Cutting Tips
Important:
Work only with sharp and undamaged cutting tips. Thus you can avoid damages to
the machine. If the cutting tips are worn or broken, replace them.
Using the supplied spanner (fig. 11.3.1, position D), loosen the screws fixing the cutting
tips (fig. 11.3.1, position C).
The cutting tips (fig. 11.3.1, position B) shall be replaced by the new ones, other ones
or turn them, so that you use all cutting edges. Caution! Due to their specific shape, be
careful while performing this task.
Re-tighten the cutting edges properly (fig. 11.3.1, position C).
Install the assembly of the guide disc according to chapter 11.2.
Fig. 11.3.1
12. Maintenance and Operation
13