HP ProDesk 600 G3 SFF Business PC Hardware Reference Manual page 39

11. To install an M.2 SSD card, slide the pins on the card into the system board connector while holding the
card at approximately a 30° angle (1). Press the other end of the card down (2), and then secure the card
with the screw (3).
12. Replace the drive cage. Slide the tabs on the right side of the drive cage into the slots on the chassis (1),
and then press the left side of the drive cage down onto the chassis (2).
13. Reconnect the power and data cables to all drives in the drive cage.
14. Replace the front bezel.
15. Replace the computer access panel.
16. If the computer was on a stand, replace the stand.
17. Reconnect the power cord and any external devices, and then turn on the computer.
18. Lock any security devices that were disengaged when the access panel was removed.
Removing and installing drives 33