Installation - AEG F88722IM0P User Manual

15. INSTALLATION

15.1 Installation
There should be a minimum
2mm gap between the top of
the dishwasher and
underside of bench top
Install the appliance under a kitchen
counter.
Put the appliance adjacent to a water tap
and a water drain.
For the venting of the appliance only
water hoses and mains cable openings
are necessary.
15.2 Adjusting the level of the
appliance
A correct adjustment of the level of the
appliance allows the door to close and
seal correctly.
If the door does not close correctly,
loosen or tighten the adjustable feet to
level the appliance.
15.3 Water connection
Water inlet hose
Connect the inlet hose to a water tap
with an external BSP thread spout of
3/4''.
The hose should not be
extended by more than
2 metres or water pump-
out problems may occur
Secure dishwasher with
brackets or screws provided
DISHWASHER
Gap on both sides should be
equal, & no greater than
5 mm per side.
If floor is not level, adjust
levelling legs to suit
Remove entire plastic
membrane from sink trap
spigot & fit drain hose to spigot
with clamp
SINK
600mm max
300mm min
POWER OUTLET
For best washing performance it is
recommended to connect the appliance
to a cold water supply.
Energy savings can be made by
connecting the appliance to a Solar
water system and using economy
options, however the water temperature
must not exceed 60° C.
Inlet water supply
• Water pressure: 800 kPa max - 50 kPa
min.
• Water flow rate 10 L / minute min.
• If water pressure is in excess of 800
kPa, a pressure reducing valve should
be used. Check for leaks.
• If water temperature is in excess of
60° C, a tempering valve should be
used. Check for leaks.
ENGLISH 21
400mm
min
Min. 400 mm straight
section