Uconnect 5.0 Owner's Manual page 63

62 NAVIGATION
Avoid Part Of Route
Press this button to avoid part of the current route.
You are shown a list of the street names on your route.
When you press one of the street names, your navigation system calculates a detour to avoid
the selected street.
The route summary shows both the new route and your original route.
Press the panel on the right to select one of the routes and then press "Done."
If you do not want to use either of the routes shown in the route summary, press "Change
route" to find another way to change your route.
CAUTION!
When a new route is calculated, you may be asked
to turn off the current road.
About Waypoints
You can choose to use waypoints for any of the following
reasons:
• You want to travel along a certain road or through a
certain area on the way to your destination.
• You want to make stops before reaching your final
destination.
When you enter a city center as a waypoint, the route
planner will plan a route via the area around this city, not
via the location of the city center. The route planner may
fail to find a route via a city center that has an awkward
location w.r.t. the current route.
Adding The First Waypoint To Your Route
To add the first waypoint to your route, do the following:
1. Press the touchscreen to bring up the Main menu.
2. Press the "Change route" button.
3. Press the "Travel via" button.
NOTE: You can also use Voice control to add Waypoints.
4. Choose the location for your waypoint from a choice
of Home, Favorite, Address, Recent destination, POI,
longitude/latitude, or position of last stop.