Receiving A Call - Accept (And End); Mute (Or Unmute) Microphone During Call; Transfer Ongoing Call Between Handset And Vehicle; Sms Message Reader - Uconnect 5.0 Owner's Manual

Receiving A Call — Accept (And End)
When an incoming call rings, or is announced on
Uconnect, push the "Phone Pick-up" button.
To end a call, push the "Phone Hang-up" button on the
steering wheel or the "Answer" button on the radio
touchscreen.

Mute (Or Unmute) Microphone During Call

During a call, push the "Voice Command" button
the steering wheel.
After the BEEP, say "mute" to mute the microphone (or
"mute off" to un-mute the microphone).
Transfer Ongoing Call Between Handset And
Vehicle
During a call, push the "Voice Command" button.
After the BEEP, say "transfer call."

SMS Message Reader

The system can read the messages received by the mobile
phone.
To use this function the mobile phone must be support
the SMS exchange function via Bluetooth.
If this function is not supported by the phone, the
corresponding button is deactivated (greyed out).
When a text message is received, the display will show a
screen where the options "Listen," "Call" or "Ignore" can
be selected.
Press the button to access the list of SMS messages
received by the mobile phone (the list displays a
maximum of 60 messages received).
on

SMS Message Reader Activation/Deactivation

The SMS message automatic reading function can be
activated/deactivated by pressing the corresponding
button on the display, which is shown after pressing the
phone selection button.
NOTE: On some mobile phones, to make the SMS voice
reading function available, the SMS notification option
on the phone must be enabled: this option is usually
available on the phone, in the Bluetooth connections
menu for a device registered as Uconnect. After enabling
this function on the mobile phone, it must be discon-
nected and reconnected with the system to make it
effective.
UCONNECT PHONE 37
6