Charging The Battery; Power Connection; Battery Charging Time; Battery Talk & Standby Times - Audiovox CDM-8410 Owner's Manual

CHARGING THE BA
CHARGING THE BA

POWER CONNECTION

1. Plug the Travel Charger into a standard outlet.
2. Plug the other end of the Travel Charger into the
bottom of your phone. The battery must be installed
on to the phone.
NOTE: 1. When you charge the battery with the phone
power off, you will see a charging status
screen. You cannot operate the phone until it
is powered on.
2. The battery is not charged at the time
of purchase.
3. Fully charge the battery before use.
4. If you use a data cable while you are
charging the battery: After using the
cable, disconnect the Travel Charger
first, then the data cable.
Page 14 - Chapter 1
TTER Y
TTER Y
Charging... Charging is
completed!
MENU FIND MENU FIND
Charging is Charging is
in progress completed
CHARGING THE BA
CHARGING THE BA
NOTE: 1. It is more efficient to charge the battery with
the handset powered off.
2. The battery must be connected to the phone
in order to charge it.
3. Battery operating time gradually decreases
over time.
4. If the battery fails to perform normally, you
may need to replace the battery.

BATTERY CHARGING TIME

Battery Type
Charging Time
NOTE: Charging time applies only when your phone is
turned off. Charging time may vary if your phone
is turned on.
BATTERY TALK & STANDBY TIMES
Digital
Talk Time
(min)
Analog
Standby
Digital
Time
Analog
(hrs)
NOTE: These times are for a new battery. Talk and
standby time may decrease over time.
TTER Y
TTER Y
BTR - 8410
200 minutes
Standard Battery
(900mAh)
180
103
145
16
Chapter 1 - Page 15