GE GSD2100V Owner's Manual page 21

Troubleshooting Tips... Before you call for service
Problem
Steam
Sanitized light does
not illuminate at the
end of the cycle
Noise
49-55114
Possible Cause
This is normal
The door was opened and
the cycle was interrupted
during final rinse
The incoming water
temperature was too low
Normal operating sounds:
Hard food disposer
shredding action.
Drain valve opening to
pump water out.
Timer control as cycle
progresses.
Detergent cup opening.
The motor stopping during
the drying period.
Water draining out of tub
immediately after touching
the start/reset pad.
Utensils are not secure in
rack or something small
has dropped into rack
Rattling dishes when the
spray arm rotates
Rattling silverware against
door during wash
Motor hums
What To Do
Warm, moist air comes through the vent during drying and
when water is being pumped out. This is necessary for drying.
Do not interrupt the cycle by opening the door during the
wash cycle.
Raise the water heater temperature to between 120°F
and 150°F.
These are all normal. No action is required.
Make sure everything is secured in dishwasher.
Make sure dishes are properly loaded. See the Loading
section.
Tall utensils may be placed in the upper rack to avoid
bumping against inner door during wash cycle.
Dishwasher has not been used on a regular basis. If you
do not use your dishwasher often, set it to fill and pump out
once every week. This will help keep the seal moist.
21