Table of Contents
Advertisement
KD-S871R
Removing the CD mechanism assembly
Prior to performing the following procedure, remove
the CD mechanism control board and the front
bracket (loading motor).
1.
Remove the three screws D
bracket.
2.
Raise the both sides fix arms and move the fix plates
in the direction of the arrow to place the four shafts g
as shown in Fig.8 and 9.
3.
Remove the CD mechanism assembly and the two
springs h attaching the flame.
4.
Remove the two screws E
damper brackets from the dampers. Detach the CD
mechanism assembly from the left side to the right
side.
ATTENTION:
The CD mechanism assembly can be
removed if only the rear damper
bracket on the left side is removed.
1-10
Downloaded from
www.Manualslib.com
(See Fig.1, 6 to 9)
and the damper
and both sides rear
manuals search engine
assembly
CD mechanism
D
h
Front bracket
assembly
CD mechanism
D
Flame
h
D
Rear damper bracket
Fix plate (L)
g
Rear damper bracket
Fix arm (R)
E
Damper
Damper bracket
D
a
h
c
D
d
CD mechanism
e
A
control board
b
Fig.5
Damper bracket
D
Fig.6
D
Fig.7
Fix arm (L)
E
g
Damper
Fig.8
Fix plate(R)
g
g
Fig.9
h
Advertisement
Table of Contents
