Index
3. Step 3 (Removing the Digital in/output PCB)
To remove the Digital in/output you need to remove three screws. On later models the
Power connection is soldered to the Molex connectors to ensure proper connection. You
will then need to place the PCB to the side. Revision B PCB's have PCB terminal blocks.
For the BNC nuts you will need a 14mm spanner. For the other nuts you will need either a
1/4" spanner or a 5mm spanner.
Lyra Maintenance Manual. D&R Electronica Weesp B.V. tel. +31 294 418041.
info@d-r.nl