Uniden UBC370CLT Owner's Manual page 7

CTCSS/DCS - You can search and display any CTCSS or DCS tone.
USB PC Programming - Lets you program your scanner using your PC.
Direct Channel Access — Press 0-9 and HOLD to directly access any stored
frequency.
Channel Lockout— Skip over stored frequencies (channels) using the
Lockout feature to enable faster scanning.
Alarm Clock with Snooze — provides standard radio broadcasts that you
can set as your alarm sound.
FM Broadcast — lets you store and search up to 30 preset FM broadcast
channels for quick access.
Priority Channel — Designate a specific frequency as a Priority Channel.
Then the radio scans and checks that channel every 2 seconds. Select and
designate up to 10 frequencies as Priority Channels (one per bank).
Priority DND — Indicates that no priority checks will be made while receiving
a transmission.
Duplicate Channel Alert — Lets you know that a selected frequency has
already been programmed into memory if you attempt to store it again.
Limit Frequency Searching — Lets you designate lower and upper
frequency range and search within that range for active frequencies.
You can then store frequencies in memory as channels for later recall.
Skip Frequency — Skips non-favorite frequencies during Service Search and
Limit Search. Up to 50 frequencies can be designated as skip frequencies.
Service Search — Lets you designate one of the seven preprogrammed
service channels (Emergency, Free Net, PMR, Marine, Aircraft, CB, HAM) to
search.
Scan and Search Speed
• Scan Speed. 100 channels per second maximum in Scan mode.
• Search Speed. 100 steps per second maximum in Search mode.
• Turbo mode. For frequency steps 5kHz apart, searching occurs in
Turbo mode which is 300 steps per second.
Clock Display — the scanner, in standby mode, displays the time.
The clock also features an alarm that can sound up to 20 minutes or be shut
off manually. A convenient snooze button lets you silence the alarm for an
extra 5-minutes.
Delay — you can enable or disable the 2-second delay to resume scanning
when a transmission ends. Enabling this feature helps prevent missing a
response from one of the parties in the transmission.
LCD Backlight — you can enable or disable the LCD back lighted display.
Key Touch Tone — a tone sounds to confirm you have made a valid key
input while a different tone sounds to alert you to an invalid entry.
7