Using Snooze; Listening To Fm Channels; Directly Selecting A Channel; Using Fm Channel Memory - Uniden UBC370CLT Owner's Manual

To have the UBC370CLT alert you at the preset time,
slide Off/Radio/Tone to either Radio or Tone. If you
set the selector to Radio, the alarm will sound with the
selected audio source (FM, Service, or Scanner). If
you set the selector to Tone, the scanner will sound a
tone at the preset time. To silence the alarm, slide Off/
Radio/Tone to Off. If you do not turn off the alarm, it
will sound for 20 minutes, then reset to alert
you again the following day.

USING SNOOZE

When the alarm sounds, press the snooze bar to
silence the alarm for 5 minutes.

LISTENING TO FM CHANNELS

To listen to FM channels, slide the mode
selector to FM when power is on. Press the button at the
top of the scanner to select the desired source (FM1,
FM2, or FM3). Radio stations are programmed into 30
channels for FM1, FM2, and FM3.

DIRECTLY SELECTING A CHANNEL

Press STEP/DIR to select the direct entry mode. Use
the ▲/▼ buttons to step through the selected band.
The scanner stops on active channels.
You can also enter the channel frequency using the
keypad. Enter the channel frequency and press E.

USING FM CHANNEL MEMORY

Your scanner has 30 FM channels for quick
channel recall (FM1/FM2/FM3).
To store a channel into memory:
1. Select the band (FM1, FM2, or FM3).
2. Directly select the channel you want to store (see
above).
3. While listening to the channel, press and hold
the number button that corresponds to the channel you want to save the
channel into for 2 seconds. The scanner switches to the Memory mode for
the current band.
18
L
Sleep
L
Service
Sleep
STEP
3
Service
STEP
3
Service