Connecting An Antenna; Using The Backlight - Uniden UBC370CLT Owner's Manual

CONNECTING AN ANTENNA

The scanner uses an external telescopic antenna
to receive all signals. Connect the supplied rod
antenna by pushing the antenna's connector
onto the antenna jack on the back of the
scanner and twisting it to the desired angle.
You can also use an external antenna (not
supplied) to help to bring in weaker signals.
Use RG58, 50-Ohm lead with a BNC connector
to connect the antenna to the scanner. Connect and mount the antenna
according to the instructions provided with the antenna.
CAUTION: Be sure to follow all safety warnings provided with the antenna.
Failure to do so could expose you to risk of injury or death and could severely
damage the scanner.

USING THE BACKLIGHT

To turn on the backlight for 15 seconds, tap SNOOZE/Light. To turn on the
backlight permanently, press and hold SNOOZE/Light for over 2 seconds. To
turn off the backlight, press and hold SNOOZE/Light again.
16